Volkswagen Golf Service & Repair Manual: Interion equipment
Repair instructions
Contact corrosion
Contact corrosion can occur if unsuitable fastening elements
(screws, bolts, nuts, washers) are used.
For this reason, only connec ...
Other materials:
Removing and installing toothed belt pulley for coolant pump, engine codes
CHPA, CMBA, CPVA, CXSA, CZDA, CZCA, CPVB
Special tools and workshop equipment
required
Counterhold -T10172- with adapter -T10172/2-
Removing
–
Remove coolant pump
→ Ch ...
Removing and installing glove compartment light switch -E26-
Note
The removal and installation procedures are described for
LHD vehicles. Removal and installation for RHD vehicles are
similar.
Removing
–
Open glove compartment.
...
Introduction
This chapter contains information on the following subjects:
→ Preparation for changing a wheel
→ Wheel bolts
→ Lifting the vehicle with the jack
→ Changing a wheel
→ After changing a wheel
Some models are delivered without a factory-fitted jack or bo ...