Volkswagen Golf Service & Repair Manual: Checking swivel joint
| – |
Firmly pull suspension link down in
-direction of arrow- and press up again. |
|
|
|
| – |
Press lower part of wheel forcefully inwards and outwards in
-direction of arrow-. |
 Note
| There should be no palpable or visible “play” during both
tests. |
| Observe swivel joint while performing tests. |
| Take into account possible existing wheel bearing play or
“play” in upper suspension strut mounting. |
| Check rubber boot for damage and renew swivel joint if
necessary. |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
Removin ...
Special tools and workshop equipment required
Ball joint puller -3287 A-
Angle wrench -V.A.G 1756-
Ring spanner insert -V.A.G ...
Other materials:
Front camera for assist systems
Removing and installing front camera for
driver assist systems
Removing
–
Switch off ignition and all electrical consumers.
–
If ignition key is present, disengage in position ...
Controls for the heating and fresh air system
Fig. 183 In the centre console: controls
for the heating and fresh air system
First read and observe the introductory information
and safety warnings
Button, control
Additional information. Heating and fresh air system
Temperature ...
Checking inertia reel (locking mechanism)
The inertia reel has two locking functions.
The first locking function is triggered by the belt being
jerked out of the reel (belt extension acceleration).
Test 1
–
Pull belt o ...
© 2016-2026 Copyright www.vwgolf.org
Removing and installing lower suspension link, vehicle with dual clutch
gearbox 0D9
Removing and installing swivel joint