Rules for cleanliness
When working on the fuel supply and injection system,
observe the following “5 rules” for cleanliness:
Thoroughly clean all unions and surrounding areas before
disconnecting.
Place removed parts on a clea ...
Evacuation and charging valve with Schrader valve
Note
Torque wrench -V.A.G 1783- with 1/4" ratchet adapter -VAS
6234-
Appropriate insert -T10364- to remove Schrader valve core
→ Fig.
A -
Service port (soldered in)
...
Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this
may be because the vehicle is inclined.
Right-hand drive vehicles or e.g. vehicles with an automatic
gearbox may lean to one side slightly.
This is due to the ins ...