Removing and installing sill panel moulding, 4-door model
Note
Removal and installation are described for the left vehicle
side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
Without needing to purge refrigerant circuit of contaminants (e.g. damage in
an accident); no refrigerant has escaped and no moisture or dirt has entered
refrigerant circuit
Drain refrigerant circuit.
–
Renew restrictor. Depending on vehicle
–
Remove receiver or reservoir.
–
Clean any dirt out of receiver or reservoir.
...
Balancing wheel, conditions
Before you start balancing the wheels, the following
requirements must be met.
Tyre pressure must be OK.
Tread must not be worn on one side. Tread depth should be at
least 4 mm.
T ...