Volkswagen Golf Service & Repair Manual: Assembly overview – battery, vehicles without high-voltage system

Volkswagen Golf Service & Repair Manual / Electrical system / Starter- current supply- CC / Battery / Assembly overview – battery, vehicles without high-voltage system

Assembly overview – battery, vehicles without high-voltage system

1 -	Retaining clip

2 -

Bolt

Specified torque: 15 Nm

3 -

Nut

Specified torque: 6 Nm

4 -	Positive cable

With battery terminal clamp

Disconnecting and connecting → Chapter

5 -

Cap

For positive cable

6 -	Heat shield sleeve

7 -

Cover

For positive battery terminal

8 -

Cover

For negative battery terminal

9 -	Electrical connector

For battery monitor control unit -J367-

Observe specified sequence for work steps when connecting earth cable → Chapter

10 -

Nut

Specified torque: 9 Nm

11 -	Earth cable

12 -	Earth cable

With battery terminal clamp and battery monitor control unit -J367-

Removing and installing → Chapter

Disconnecting and connecting → Chapter

Adapting battery monitor control unit -J367- → Chapter

13 -	Battery -A-

Removing and installing → Chapter

Disconnecting and connecting → Chapter

Renewing (on vehicles equipped with Start/Stop system) → Anchor

14 -	Battery tray

Removing and installing → Chapter

15 -

Bolt

Qty. 3

Specified torque: 9 Nm

Battery

...

Assembly overview – battery, vehicles with high-voltage system

1 - Battery tray 2 - Battery cover 3 - Retaining clip 4 - Nut 20 Nm ...

Other materials:

Assembly overview - trailing arm, except for e-Golf
1 - Cover 2 - Bolt Renew after removing 50 Nm +45° 3 - Mounting bracket 4 - Bolt Renew after removing 90 Nm& ...

Loading the trailer
First read and observe the introductory information and safety warnings Trailer weight and drawbar load The trailer weight is the weight that the vehicle can pull . The drawbar load is the weight that the towing bracket exerts on the ball coupling vertically from above . The figure ...

Assembly overview - skid plate
Note The removal and installation procedures may have to be modified slightly depending on engine fitted. 1 - Underride guard Removing – Remove bolts -2-, -3- and -4-. – Pull out noise ...