Volkswagen Golf Owners Manual: Indicator lamps

Volkswagen Golf Owners Manual / While driving / Driver assist systems / Pull-away assist systems / Indicator lamps

First read and observe the introductory information and safety warnings

Lit up	Possible cause	Solution
	The vehicle is being held by the electronic parking brake.	Switch off the Auto Hold function if necessary .
	The start/stop system is available. The engine is switched off automatically.	–
	It is not possible for the start/stop system to switch the engine on or off automatically. OR: the engine was restarted automatically.	–

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

Failure to observe illuminated warning lamps and text messages can lead to your vehicle breaking down in traffic, and can cause accident and serious injury.

Never ignore any illuminated warning lamps or text messages.

Stop the vehicle as soon as possible and when safe to do so.

NOTICE

Failure to observe illuminated indicator lamps and text messages can lead to your vehicle being damaged.

Introduction

This chapter contains information on the following subjects: → Indicator lamps → Auto Hold function → Start/stop system → Downhill driving assistant � ...

Auto Hold function

Fig. 146 In lower part of centre console: button for Auto Hold First read and observe the introductory information and safety warnings The indicator lamp in the button (arrow) ...

Other materials:

Safety precautions when painting natural gas-powered vehicles
DANGER! Excessively high drying temperatures endanger life! High temperatures increase the pressure in the tank for natural gas or liquefied petroleum gas. Excessive pressure can cause the tank for natural ...

Removing and installing charge pressure sender -GX26-
Charge pressure sender -GX26- consists of Charge air pressure sender -G31- Intake air temperature sender -G42- Removing – ...

Assembly overview - short noise insulation
Note The removal and installation procedures may have to be modified slightly depending on engine fitted. 1 - Short noise insulation Removing – Remove bolts -2- and -3- – Pull out noise ...