VW Golf manuals

Volkswagen Golf Service & Repair Manual: Changing headlights over from driving on left to driving on right, LED headlights

Volkswagen Golf Service & Repair Manual / Electrical system / Lights, lamps, switches outside / Headlight / Changing headlights over from driving on left to driving on right, LED headlights

If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling oncoming traffic with the asymmetric low beam headlights.
  Note
The conversion from driving on left to driving on right, or vice versa, is performed by means of the infotainment system.
It is only permissible to make use of the headlight converter for a short period of time. When permanently driving in the respective country during a longer period of time, suitable headlights need to be installed according to valid specifications.
–  On the display unit for front information display and operating unit control unit -J685-, press button CAR.
–  Press function buttons Setup and Light.
–  Perform adjustment in menu “Light Settings”.
   
Changing headlights over from driving on left to driving on right (gas discharge headlights with dynamic high beam control and LED daytime running light)
If a right-hand drive vehicle is driven in a left-hand drive country, or vice versa, the headlights must be converted. This is necessary in order to avoid dazzling on ...

Removing and installing headlight range control motor -V48-/-V49- (dual halogen headlights)
  Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. ...

Other materials:

Removing automatic distance control unit from and installing on adapter frame, variant 2
Removing –  Remove adaptive cruise control unit -J428- → Chapter.     –  Detach fasteners -1- on both sides in direction of arrow -A-. ...

Declaration of conformity
First read and observe the introductory information and safety warnings The individual manufacturer declares herewith that the following products conform, at the time of vehicle production, with the basic requirements and other relevant laws and regulations, including FCC Part 15.19, FCC Par ...

Removing and installing rear tunnel cross-piece
Special tools and workshop equipment required         Torque wrench -V.A.G 1331- Removing –  Loosen rear underbody panel and press downwards slightly ...

© 2016-2020 Copyright www.vwgolf.org