FunctionRemoving and installing Bowden cable for remote release mechanism for seat
backrest
Note
Removal and installation are described for the left vehicle side.
Follow same instructions for the right side as appropriate.
Removing
Bowden cable on backrest end
–
Remove rear seat backrest
→ Chapter.
...
Renewing rear bonded rubber bush
Special tools and workshop equipment required
Tensioning strap -T10038-
Assembly tool -T10263-
Assembly tool -T10356-
Engine and gearbox jack -V.A.G 1383 A-
Hydraulic press -VAS 6178- and thrust piece - ...
Removing and installing speed sensors on front axle -G45-/-G47-
Note
Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous.
Removing
–
Raise vehicle.
&n ...