VW Golf manuals

Volkswagen Golf Service & Repair Manual: Wheel alignment procedure

Always adhere to the following procedure!
  Note
The vehicle must always be in unladen condition when measuring wheel alignment → Chapter.
   
–  Take note of the information in the wheel alignment unit.
 

Wheel alignment procedure

Alignment procedure
                 
  Start Carry out wheel run-out compensation. Bounce springs.  
               
  Turn steering wheel to straight-ahead position and fix in place → Remark. Measure vehicle height. Fit brake pedal depressor -V.A.G 1869/2-  
               
  Check front axle camber Is actual value within tolerance? No  
             
    Yes   Adjust → Chapter.  
             
     
               
  Check rear axle camber Is actual value within tolerance? No  
             
    Yes   Checking (torsion beam axle) → Chapter Adjusting (multi-link suspension) → Chapter  
             
     
               
  Check rear axle toe Is actual value within tolerance? No  
             
    Yes   Checking (torsion beam axle) → Chapter Adjusting (multi-link suspension) → Chapter  
             
     
               
  Check front axle caster Is actual value within tolerance? No  
             
    Yes   Inspect axle components and body  
             
     
               
  Check front axle toe Is actual value within tolerance? No  
             
  End Yes   Adjust → Chapter.  
             
     
 
1)  If steering wheel is not centred, it must be straightened after wheel alignment is finished. Then carry out basic setting for steering angle sender -G85- using → Vehicle diagnostic tester.
  Note
If adjustments have been made to the suspension after a wheel alignment check on vehicles with ESP or ABS, the steering angle sender -G85- must be calibrated using the → Vehicle diagnostic tester.
If any changes are made to the rear wheel alignment settings, the following driver assist systems must be recalibrated:
Lane departure warning (Audi lane assist) → Chapter „Calibrating front camera for driver assist systems“,
ACC → Chapter „Calibrating adaptive cruise control (ACC), except for e-Golf“.
   
Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this may be because the vehicle is inclined. Right-hand drive vehicles or e.g. vehicles with an ...

Necessity of wheel alignment, torsion beam axle
Wheel alignment is necessary if: The vehicle does not handle properly. Vehicle has been involved in an accident and comp ...

Other materials:

Assembly overview - tyre pressure sensor, tyre pressure sensor with valve
1 -  Tyre pressure sensor Supplied complete as spare part. Removing and installing → Chapter Replace complete tyre pressure sensor when battery is dead After using breakdown set, wipe clean h ...

Removing and installing washer jets
Removing   Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. –  Open bonnet.   & ...

Adjusting the head restraints
Fig. 46 Adjusting front head restraint Fig. 47 Adjusting rear head restraint First read and observe the introductory information and safety warnings Every seat is fitted with a head restraint. The centre rear head restraint is designed solely for use with the centre rear seat. This head ...

© 2016-2024 Copyright www.vwgolf.org