Volkswagen Golf Owners Manual: Warning lamp and coolant temperature display
Fig. 194 Coolant temperature display in instrument cluster: Ⓐ cold; Ⓑ normal; Ⓒ warning
First read and observe the introductory information
and safety warnings In normal driving conditions, the needle will be in the middle section of the scale. The temperature may also rise when the engine is working hard, especially at high ambient temperatures.
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.
| Flashesa) |
Needle position |
Possible cause | Solution |
|---|---|---|---|
 |
Ⓒ Warning area |
Coolant temperature too high. |
 Do not drive on! Stop the vehicle as soon as possible, and when safe to do so. Stop the engine, let the engine cool down until the needle is back in the normal area. Check the coolant level . |
|
Ⓑ Normal area |
Coolant level too low. | After
the engine has cooled down, check the coolant level and refill engine coolant
if the level is too low . There is a fault if the coolant level is correct. |
|
| – | Fault in the coolant system. |
Do not drive on! Seek expert assistance. |
|
| – |
Ⓐ Cold |
The engine has not yet reached operating temperature. | Avoid high engine revs and heavy engine loads until the engine is warm. |
WARNING
- Never ignore any illuminated warning lamps or text messages.
- Stop the vehicle as soon as possible and when safe to do so.
NOTICE
a) Displayed in colour on an instrument cluster with colour display.
Introduction
This chapter contains information on the following subjects:
→ Warning lamp and coolant temperature display
→ Coolant specification
→ Checking the coolant level and ...
Coolant specification
First read and observe the introductory information
and safety warnings The cooling system is filled at the factory with a mixture
of specially prepared water and at least 40% coolant additive G ...
Other materials:
Removing broken front side window
Removal of a broken front side window is performed in the
same manner as the removal of a broken rear window
→ Chapter.
Removing and installing rear side window
Note
...
Mobile telephone preparation, Bluetooth hands-free system
Bluetooth hands-free system is integrated in control unit 1
for information electronics -J794-.
Connection to mobile telephone -R54- is established via
Bluetooth.
Aerial for Bluetooth -R152- is integrated into control un ...
Removing and installing side trim panel
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...
