Volkswagen Golf Service & Repair Manual: Vehicles with multilink suspension
The connecting pipe can be cut through at the cutting point
in order to renew the centre and rear silencers separately. |
Cutting point is marked by an indentation on circumference
of exhaust pipe. |
Special tools and workshop equipment
required |
|
|
|
Chain-type pipe cutter -VAS 6254- |
|
|
|
– |
Cut through exhaust pipe at right angles at cutting point
-arrows- using chain pipe cutter
-VAS 6254-. |
|
|
|
– |
Position clamp centrally at side marks
-arrows- when installing. |
|
|
|
The connecting pipe can be cut through at the cutting point
in order to renew the centre and rear silencers separately.
Cutting point is marked ...
Procedure
The exhaust system must be aligned when cold.
Note
The -arrow- points forwards.
  ...
Other materials:
General repair instructions
–
→ Chapter „Safety precautions when working on high-voltage
system“ Comply with notes.
–
Read self-diagnosis of auxiliary heater using vehicle
diagnostic tester.
–
...
Indicator lamp in the vehicle key
Fig. 24 Indicator lamp in the vehicle key
First read and observe the introductory information
and safety warnings If a button on the vehicle key is pressed briefly, the
indicator lamp (arrow) flashes once. The lamp will flash several times if the
button is pressed and held, e.g. conve ...
Removing and installing lock carrier – petrol/diesel
Note
The lock carrier is a safety-relevant component. For this reason, the
lock carrier must only be repaired at the points indicated.
In the event of damage, renew lock carrier
For vehicles with adaptive cruise control unit -J428-, the adaptive
cruise control unit -J428- must be adjus ...
© 2016-2024 Copyright www.vwgolf.org