Volkswagen Golf Service & Repair Manual: Valve gear
- Assembly overview - valves
- Removing and installing camshaft control valve 1 -N205- and exhaust camshaft control valve 1 -N318-
- Removing and installing camshaft adjuster
- Measuring axial play of camshaft
- Removing and installing inlet camshaft oil seal, pulley end, engine codes CPTA, CHPA, CZEA, CZDA
- Removing and installing exhaust camshaft oil seal, pulley end, engine codes CPTA, CHPA, CZEA, CZDA
- Removing and installing exhaust camshaft oil seal, gearbox end, engine codes CHPA, CMBA, CPVA, CXSA, CZDA, CZCA, CPVB
- Removing and installing valve stem seals (cylinder head installed)
- Removing and installing valve stem seals (cylinder head removed)
Checking compression
Special tools and workshop equipment
required
Spark plug socket and extension -3122 B-
...
Assembly overview - valves
1 -
Inlet valve
Do not rework. Only lapping in is permitted.
Valve dimensions
→ Chapter
Checking valve guid ...
Other materials:
EU general type approval number, sales type and sales or trade designation
The designations below are only applicable for VW vehicles
Since 1.1.1998, all passenger cars licensed within the European
Union must have a type approval corresponding to EU guidelines. Vehicles
licensed for road use with single-vehicle approval according to § 21
St ...
Removing and installing ignition coils with output stage
Special tools and workshop equipment
required
Puller -T10530-
Note
The ignition coils are easier to remove when the engine is
warm. The grease used durin ...
Assembly overview - suspension strut, shock absorber, spring, multi-link
suspension
1 -
Bolt
Renew after removing
50 Nm +45°
2 -
Shock absorber
Removing and installing
→ Chapter
Note correct installation position of cable tie fastener. ...
