VW Golf manuals

Volkswagen Golf Service & Repair Manual: Vacuum generation with manual vacuum pump -VAS 6213-

Volkswagen Golf Service & Repair Manual / Brake system / Brakes, hydraulics, regulator, servo / Vacuum system / Vacuum generation with manual vacuum pump -VAS 6213-

In certain cases, vacuum can be generated with the manual vacuum pump -VAS 6213- instead of with the engine or the vacuum pump.
–  To do this, connect manual vacuum pump -VAS 6213- to vacuum hose from connection -B- on brake servo vacuum gauge -VAS 6721-.
–  Open cut-off valve -B-.
–  Generate vacuum with hand vacuum pump -VAS 6213- until between 600 and 950 mbar is shown on brake servo vacuum gauge -VAS 6721-.
–  Then, carry out the corresponding checks.
 

Vacuum generation with manual vacuum pump -VAS 6213-

Checking for leaks
  Note The average air pressure of the earth's atmosphere at sea level is 1013 mbar and decreases steeply as the altitude increases (approx. 100 mb ...

Brake lines
...

Other materials:

Removing and installing window regulator motor -V14-/-V15-
  Special tools and workshop equipment required       Note    Removal and installation are only described for the left window regulator motor. Removal ...

Refrigerant pressure and temperature sender -G395
  WARNING Danger of freezing injuries. If refrigerant circuit has not been evacuated, refrigerant will escape. The refrigerant must be extracted before removi ...

Removing and installing lambda probe 1 before catalytic converter -GX10-/lambda probe 1 after catalytic converter -GX7-
Lambda probe 1 before catalytic converter -GX10- consists of Lambda probe -G39- Lambda probe heater -Z19- Lambda probe 1 after catalytic converter -GX7- consists of Lam ...

© 2016-2024 Copyright www.vwgolf.org