Volkswagen Golf Service & Repair Manual: Uprated shock absorbers and coil springs

Volkswagen Golf Service & Repair Manual / Guide for using trailers / Technical prerequisites / Uprated shock absorbers and coil springs

Diving or dipping of the rear end between pulling vehicle and trailer can be avoided with the use of uprated shock absorbers and coil springs on the rear axle. These shock absorbers and springs can also be retrofitted in many cases by a Volkswagen workshop, unless of course they were installed ex-factory. For allocation of the shocks and springs refer to → Electronic parts catalogue “ETKA”.

Diving or dipping and trailer snaking can also be avoided with stabilisation aids that can be procured in most European countries via Volkswagen dealerships and also installed by them.

Notes on operation and driving

Note

It is essential that the notes on operation and driving, which can be found in the operating instructions of your vehicle, are read and observed.

Engine cooling

Since higher demands are placed on the engine cooling system when a trailer is being towed, the cooling system is uprated in conjunction with factory fitted towing at ...

General

...

Other materials:

Removing and installing rear wheel housing liner
Special tools and workshop equipment required Torque wrench -V.A.G 1783- Note Removal and installation are descr ...

Overview of fitting locations – lights in rear doors
1 - Door warning lamp and entry light Driver side door warning lamp -W30- and front passenger entry light -W93- Front passenger side door warning lamp -W36- and driver side entry light -W92- Removing and installing ...

Removing and installing drive shaft
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Press tool -T10520- ...