Fig. 7 Overview of the upper section of the centre console
Key for :
Infotainment system (factory-fitted)
Controls for:
Removing and installing crash bar
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331
Removing
–
Remove knee airbag with igniter
...
Assembly overview - drive shaft, constant velocity joint VL100
1 -
Outer constant velocity joint
Renew only as complete unit
Removing
→ Anchor.
Installing: drive onto shaft to stop using plastic hammer
Checking
→ Chapter
2&nb ...
Removing and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
be spread and the flanks will be bent out slightly. If the seal is then
refitted, sealing and fir ...