Fig. 214 Removing the cover of the gearshift gate
Fig. 215 Unlocking the selector lever lock manually (Variant A) and (Variant B)
If the power fails in the vehicle (for example if the battery is discharged) and the vehicle has to be pushed or towed, the manual release mechanism must be used to put the selector lever in the N position.
The manual release mechanism is located under the cover of the gearshift gate on the right-hand side, as seen from the direction of travel.
Preparation
Removing the cover of the gearshift gate
Unlocking the selector lever lock manually Variant A
Unlocking the selector lever lock manually Variant B
WARNING
The automatic gearbox will become damaged if the vehicle is allowed to roll for a long period of time or at a high speed (for example while being towed) with the selector lever in position N and the engine switched off.
Searching for leaks in refrigerant circuits using leak detector -V.A.G 1796
Note
Small leaks can be detected with, for example, an electronic
leak detector.
–
Evacuate refrigerant circuit using an air conditioner
service station
→ Chapter.
Note
...
Conducting a road test before balancing wheels
If a customer brings a vehicle to the workshop complaining
about “vibration”, a road test is essential prior to balancing
the wheels.
This will give you information about the nature of the
vibration.
...
Removing and installing voltage regulator, manufacturer: Bosch
Special tools and workshop equipment
required
Offset screwdriver for slotted-head screws -VAS 6416-
Torque screwdriver -V.A.G 16 ...