Volkswagen Golf Owners Manual: Underseal
First read and observe the introductory information
and safety warnings
The underside of the vehicle is coated to protect it from corrosion and damage. The protective coating on the underside of the vehicle could be damaged when driving. Volkswagen therefore recommends that the protective coating on the underside of the vehicle and on the running gear should be checked regularly and repaired if necessary.
CAUTION
- Never apply underseal or anti-corrosion coatings to the exhaust pipes, catalytic converter, heat shields or other vehicle components that become hot.
De-icing the door lock cylinders
First read and observe the introductory information
and safety warnings Volkswagen recommends the use of genuine Volkswagen spray
with lubricating and anti-corrosive properties to de-ice the loc ...
Cleaning the engine compartment
First read and observe the introductory information
and safety warnings The engine compartment of any motor vehicle is a hazardous
area .
The engine compartment should be cleaned by a qual ...
Other materials:
Removing and installing data bus diagnostic interface -J533-
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester.
Removing
...
Adjusting clutch engagement
The position of the engagement bearings “K 1” and “K 2” must
only be adjusted after the following work:
Clutch has been renewed.
Engaging levers were renewed.
Small ba ...
COC document (EEC Certificate of Conformity)
Manufactures of motorized vehicles must apply for an EU
operating permit for all class M1 passenger carrying vehicles.
A certificate is produced on the basis of this operating
permit - the COC (Certificate of Conformity).
...
