Sockets in the vehicle
IntroductionRemoving and installing B-pillar trim on rear door
Note
Removal and installation are described only for the left side.
Removal and installation of the right side are similar.
Removing
–
Run door window down to bottom position.
–
Pull window channel -3- in area ...
Removing and installing ignition coils with output stage
Special tools and workshop equipment
required
Puller -T10530-
Note
The ignition coils are easier to remove when the engine is
warm. The grease used durin ...
Contact corrosion
Contact corrosion can occur if unsuitable fasteners (bolts,
nuts, washers, etc.) are used.
Therefore, only fastening elements with a special surface
coating are installed in the vehicle.
In addition, rubber and plastic p ...