VW Golf manuals

Volkswagen Golf Owners Manual: The dangers of assuming an incorrect sitting position

First read and observe the introductory information and safety warnings

If the seat belts are not worn or are worn incorrectly, the risk of severe or fatal injuries increases. Seat belts can only provide optimal protection if the seat belt routing is correct. Assuming an incorrect sitting position considerably impairs the level of protection provided by a seat belt. This could lead to severe or even fatal injuries. The risk of severe or fatal injuries is especially increased when a deploying airbag strikes a vehicle occupant who has assumed an incorrect sitting position. The driver is responsible for all occupants transported in the vehicle, especially children.

The following list contains examples of sitting positions that can be dangerous for all vehicle occupants.

Whenever the vehicle is in motion:

WARNING

Every incorrect sitting position in the vehicle increases the risk of severe or fatal injuries in the event of an accident or sudden driving or braking manoeuvre.
Introduction
This chapter contains information on the following subjects:  → The dangers of assuming an incorrect sitting position    → Correct sitting position    → Mechanical control ...

Correct sitting position
Fig. 41 There must be a distance of at least 25 cm between the driver and the steering wheel The distance to the dash panel must be at least 10 cm in the knee area Fig. 42 Correct seat belt rout ...

Other materials:

Nuts and bolts
Loosen and tighten securing bolts and securing nut for covers and housings diagonally. Specified torques settings are specified for unoiled bolts and nuts. Threads of bolts secured with locking fluid must be ...

Removing and installing interface for entry and start authorisation system -J965-
  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester. The removal and insta ...

Corrosion protection measures for wing surface in contact with wheel housing liner
  Note   The corrosion protection measure is to be carried out in the groove of the wing of all new replacement parts which have not had the additional sealant applied at the factory.   The additional sealant is intended to prevent the wheel hous ...

© 2016-2026 Copyright www.vwgolf.org