Volkswagen Golf Service & Repair Manual: Test preparations, wheel alignment with no driver assist systems
Special tools and workshop equipment required |
Wheel alignment computer -V.A.G 1813F- or VW/Audi-approved wheel
alignment units |
Brake pedal depressor -V.A.G 1869/2- |
Tool insert 18 mm -T10179- |
Shock absorber set -T10001- |
The existing lateral run-out of the wheel must be
compensated for. Otherwise, the result of the measurement will
be incorrect. |
If run-out compensation is not performed, it is not possible
to adjust toe-in correctly! |
Please follow the instructions of the manufacturer of the
wheel alignment equipment. |
– |
Carry out wheel runout compensation. |
– |
Apply brake pedal depressor -V.A.G 1869/2-. |
– |
Use brake pedal depressor to depress brake pedal. |
Preparations required before calibration of driver assist
systems |
|
Check wheel suspension, wheel bearing assembly and steering
for excessive play and damage.
Tread depth difference of no more than 2 mm on ...
The following steps are required if one or more driver
assist systems on the vehicle are to be calibrated via the
“Quick-start” procedure (i.e. without first chec ...
Other materials:
Technical data
Capacities for refrigerant R134a
Air
conditioner compressor
Manufacturer
Total
capacity
6SES14C
Manufacturer: Denso.
500 ± 15 grammes
11PXE14
Sanden
500 ± 15 grammes
6CVC140
Manufacturer:
Delp ...
Disconnecting and connecting battery, vehicles without high-voltage system
Caution
Observe the following instructions and precautions
on safety when working on pyrotechnic components:
Contrary to the following description, the battery
must be disconnected ...
Electronic immobilizer
First read and observe the introductory information
and safety warnings The immobilizer helps to prevent the engine from being
started and driven with an unauthorised vehicle key.
There is a chip in the key. It automatically deactivates the immobilizer when
the vehicle key is inserted into ...
© 2016-2024 Copyright www.vwgolf.org