Volkswagen Golf Service & Repair Manual: Test preparations, wheel alignment with driver assist systems
| The following steps are required if one or more driver
assist systems on the vehicle are to be calibrated via the
“Quick-start” procedure (i.e. without first checking and
adjusting the wheel alignment): |
| Before driving the vehicle onto the alignment platform, make
sure there is sufficient space between the vehicle and the
calibration unit. The distance between the calibration unit and
the vehicle must be 120 cm ± 2.5 cm. |
| If the available space is not adequate, move the vehicle
backwards on the alignment platform as required. This allows the
use of the respective floor area. |
| Before starting calibration, read out event memory and
rectify any faults. |
| Vehicle accurately aligned, suspension bounced and rocked
several times. |
| When checking wheel alignment, ensure that sliding plates
and turn tables are not touching end stop. |
| Connect battery charger
→ Vehicle electrics; Rep. gr.27. |
| Move front wheels to straight-ahead position. |
| Connect → Vehicle
diagnostic tester to vehicle, route diagnostic cable
through open door window. |
| Vehicle exterior lighting switched off. |
| All doors of vehicle are closed. |
| Press button to select required calibration on wheel
alignment computer. |
|
|
|
Special tools and workshop equipment required
Wheel alignment computer -V.A.G 1813F- or VW/Audi-approved wheel
alignment units
Brake pedal depressor ...
These specifications apply to all engines.
Explanations regarding PR numbers
→ Chapter „Vehicle data sticker“.
Front axle
Basic
...
Other materials:
Introduction
This chapter contains information on the following subjects:
→ Tyre monitoring indicator lamp
→ Tyre monitoring display
Additional information and warnings:
Volkswagen information system
Infotainment system
Transporting
Braking, stoppi ...
Removing and installing headlight main beam bulb -M30-/-M32- (LED)
Special tools and workshop equipment
required
Front-end hook -3370-
Torque wrench -V.A.G 1783-
...
Removing and installing fuse holder A -SA-
Removing
–
Remove fuse holder B
→ Chapter.
–
Take securing bar -4- out of
fuse holder B upwards.
–
Release retaining tab -1--arrow-
a ...
© 2016-2024 Copyright www.vwgolf.org
Test preparations, wheel alignment with no driver assist systems
Specified values for wheel alignment, torsion beam axle, Golf