Volkswagen Golf Service & Repair Manual: Sump, oil pump
- Assembly overview - sump and oil pump
- Removing and installing oil level and oil temperature sender -G266-
- Removing and installing lower part of sump
- Removing and installing oil pump
- Removing and installing upper part of sump
Assembly overview - sump and oil pump
Note
Metal shavings or a large quantity of small metal particles found
during engine repair could indicate that the crankshaft bearings or
conrod bearings are damaged. To ...
Other materials:
Checking fuel pressure
Special tools and workshop equipment required
Removal wedge -3409-
Pressure tester -VAS 6550-
Connector cable -VAS 6550/3-3-
Connector cable -VAS 6550/3-4-
Vehicle diagnostic tester
...
Changing the bulb in the number plate light
Fig. 241 In the rear bumper: number plate
light
Fig. 242 Number plate light: removing the
bulb holder
First read and observe the introductory information
and safety warnings
The actions should only be carried out in the specified order:
1. ...
Assembly overview - speed sensor on rear axle, front-wheel drive
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
Removing and installing
→ Chapter
2 -
Bolt
...
