
Fig. 113 Stowage compartment on the front passenger side

Fig. 114 Open stowage compartment on the front passenger side
First read and observe the introductory information
and safety warnings Opening and closing the stowage compartment
If necessary, unlock the stowage compartment. The stowage compartment is locked when the key slot is vertical.
To open, pull up the opening lever .
To close, push the cover up.
Vehicle wallet compartment
The stowage compartment on the front passenger side is intended for the vehicle wallet. The vehicle wallet should always be kept in this compartment.
Depending on the vehicle equipment level, you may find a separate vehicle wallet compartment in the upper region of the luggage compartment .
Infotainment system devices, card readers
The upper area of the stowage compartment may contain infotainment system devices and card readers ⇒ BookletRadio, or ⇒ BookletNavigation system, .
Cooling the stowage compartment
A vent in the upper area of the stowage compartment can be used to feed cooled air into the stowage compartment when the air conditioning is switched on. Turn the vents to open and close them.
Coin holder, mounting for glasses compartment
The stowage compartment cover may contain a coin holder and a mounting for a glasses compartment .

WARNING

NOTICE
Stowage compartment in the front centre armrest
Stowage compartment in the rear centre consoleAssembly overview - anti-roll bar, multi-link suspension, four-wheel drive
1 -
Lower transverse link
2 -
Nut
Renew after removing
20 Nm +180°
3 -
Coupling rod
Removing and installing
→ Chapter
4 -
...
Checking the electrolyte level of the vehicle battery
Fig. 197 Engine compartment: pushing up
the vehicle battery sleeve
First read and observe the introductory information
and safety warnings The electrolyte level of the vehicle battery should be
checked regularly in high-mileage vehicles, in hot countries and in older vehicle
batteries. T ...
Removing and installing tyre pressure sensor, Siemens tyre pressure
monitoring system
WARNING
After tyre sealant has been used, the tyre pressure
sensor of the respective wheel must be renewed.
The Siemens system does not have a micro-encapsulated bolt.
...