Notes to repairs on refrigerant circuit
Statutes and regulationsRemoving and installing rear lid seal
In the factory a sealant is applied to the rear lid seal, the seal is fitted
to the body flange and then rolled on.
Note
When the seal is removed, the sealant on the inside of the seal will
be spread and the flanks will be bent out slightly. If the seal is then
refitted, sealing and fir ...
Switching off auxiliary and supplementary heater
If the button instant heat button has been pressed, or after
the preset operating time has expired or the coolant has reached
a temperature of 88° C, the combustion is ended and the run-on
mode begins. The circulation pump -V55- and the combustion air
...
Assembly overview - anti-roll bar, multi-link suspension, front-wheel drive
1 -
Lower transverse link
2 -
Nut
Renew after removing
20 Nm +180°
3 -
Coupling rod
Removing and installing
→ Chapter
4 -&nb ...