Overview of fitting locations - front control motors, LHD vehicles
1 -
Temperature flap control motor -V68-
Checking: with vehicle diagnostic tester
Removing and installing
→ Chapter
Renewing: initiate basic setting using vehicle diagnostic tester.
2 -&nbs ...
Checking pistons and cylinder bores
Checking piston
–
Using a micrometre, measure approx. 10 mm from the lower
edge, perpendicular to the piston pin axis.
Maximum deviation from nominal dimension: 0.04 mm
...
Removing and installing wheel housing trim, saloon
Note
Removal and installation are described for the left
vehicle side. Follow same instructions for the right side as
appropriate.
Special tools and workshop equipment
required
...