Volkswagen Golf Service & Repair Manual: Snow chains

Volkswagen Golf Service & Repair Manual / Wheels and Tyres Guide - General Information / Snow chains

Assembly and use of snow chains

Snow chains must be fitted to driven wheels only.

On all-wheel drive vehicles, however, only the front wheels may be fitted with snow chains.

It is not possible to use snow chains with all wheel and tyre combinations. Notes on this can be found in the vehicle tables of the certificate statement.

If no particular type of snow chain is specified, then small-link chains may be used. These, including the chain fastener, may not protrude more than 15 mm beyond the wheel's tread and the inner wall.

On some models, only special, small-link chains are possible with certain wheel and tyre combinations. Notes on this can be found in the vehicle tables of the certificate statement.

The maximum speed permitted by law when driving with snow chains is 50 km/h.

Snow chains should be removed when there is no snow on the road. There is no point in having them on the wheels, as they adversely affect the vehicle's handling. It causes unnecessary stress on the tyres and above average wear on the chains.

Wheel bolts, adapter sets for anti-theft wheel bolts

Special tools and workshop equipment required Torque wrench -V.A.G 1332- A ...

Temporary spare wheels

Notes on temporary spare wheels Inform your customers about the following notes and, if appropriate, refer also to the user's manual of the vehicle a ...

Other materials:

Removing and installing front parking aid warning buzzer -H22-, LHD vehicles
Removing – Remove trim under dash panel → General body repairs, interior; Rep. gr.68. – Using a small screwdriver -1-, press front parki ...

Run-flat tyres, PAX, inflating tyre
Observe the following important points when inflating the tyre: – Only inflate after fitting the tyre with valve core installed. Check whether the beads have properly seated at 1 bar. – ...

Extraction and charging valve, high-pressure side
Note Torque wrench -V.A.G 1783- with 1/4" ratchet adapter -VAS 6234- Appropriate insert -T10364- to remove valve core → Fig. 1 - Base with external or internal thread ...