Volkswagen Golf Service & Repair Manual: Silicone remover
| Aqueous silicone remover -LSW 019 000 A5- |
| Silicone remover -LVM 020 000 A5- |
| Slow-drying silicone remover -LVM 020 100 A5- |
| Product description - silicone remover -LSW 019 000 A5- |
| The silicone remover -LSW 019 000 A5- is an aqueous cleaner
with no special labelling requirements, containing a small
proportion of organic solvents and special cleaning additives. |
| Product description - silicone remover -LVM 020 000 A5- and
slow-drying silicone remover -LVM 020 100 A5- |
| Silicone remover -LVM 020 000 A5- is a quick-evaporating
mixture. Slow-drying silicone remover -LVM 020 100 A5- is a
mixture of slow-evaporating organic solvents. Both are used
primarily to remove oil and grease residues. |
| The above-named silicone removers are used for cleaning
sanded old or factory finishes, and surfaces coated with primer
and surfacer which has been subsequently sanded, before these
are treated further. |
| Apply silicone remover using a spray bottle or a clean
non-woven cloth. |
| Dry the surface with a dry non-woven cloth before the
silicone remover evaporates. |
| Allow cleaned surfaces to dry completely or blow dry before
recoating. |
 Note
| Allow cleaned surface to dry completely before recoating. |
| Do not allow silicone remover to dry on the surface. |
| The product is not suitable for cleaning spray guns or
tools. |
| Always use a clean cloth, and be sure to renew it early
enough if dirty or worn out. |
| Heavily soiled parts must be cleaned twice. |
| Silicone remover -LSW 019 000 A5- is not suitable for
removing release agent residues from UP-GF or other plastic
surfaces. |
|
|
|
| Personal protective equipment: |
| Adhere to the safety data sheet. |
| Wear personal protective equipment during application. |
| Technical data - silicone remover -LSW 019 000 A5- |
|
|
|
| Flash point: |
Above +23 °C |
| VOC value:
2004/42/IIB(a)(200)200 |
The EU limit value for this
product (product category IIB.b) in ready-to-spray form is max. 200 g/l
of volatile organic compounds. The VOC content of this product in
ready-to-spray form is max. 200 g/l. |
| Technical data - silicone remover -LVM 020 000 A5- |
|
|
|
| Flash point: |
Above +4 °C |
| VOC value:
2004/42/IIB(a)(850)770 |
The EU limit value for this
product (product category IIB.b) in ready-to-spray form is max. 850 g/l
of volatile organic compounds. The VOC content of this product in
ready-to-spray form is max. 750 g/l. |
| Technical data - slow-drying silicone remover -LVM 020 100
A5- |
|
|
|
| Flash point: |
Above +26 °C |
| VOC value:
2004/42/IIB(a)(850)770 |
The EU limit value for this
product (product category IIB.b) in ready-to-spray form is max. 850 g/l
of volatile organic compounds. The VOC content of this product in
ready-to-spray form is max. 770 g/l. |
| The guaranteed shelf life is 60 months from date of
production. May be used until the date stated on the label at
latest if stored in sealed original containers at +20 °C. |
|
|
|
Designation:
Cleaner for plastics -D 195 850 A1-
Issued 04.2009
Product description
...
Other materials:
Assembly overview - drive shaft
1 -
Outer constant velocity joint
Renew only as complete unit
Removing
→ Fig..
Installing: drive onto shaft to stop using plastic hammer
Distribute grease evenly in joint
Ch ...
Renewing Lambda probe
Note
Do not repair Lambda probe wires, since this can result in
malfunctions.
If necessary, replace attachment parts, cable ties or
marking rings to match the uniform probe to the defective probe
as specified. ...
Perform battery test with battery tester with printer -VAS 6161-.
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
Special tools and workshop equipment
required
...
© 2016-2024 Copyright www.vwgolf.org
Cleaning agents
Cleaner for plastics