Volkswagen Golf Service & Repair Manual: Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this
may be because the vehicle is inclined. |
Right-hand drive vehicles or e.g. vehicles with an automatic
gearbox may lean to one side slightly. |
This is due to the installation position of the assemblies
and their associated weight transfer and is normal. |
– |
In such cases it is essential to measure dimension
-a- at the rear on both sides. |
– |
Correct any differences as required. |
On the front axle, compensate by adding weights to the top
of the respective suspension turret. |
On the rear axle, compensate by adding weights to the
respective side of the luggage compartment. |
Sand-filled sacks (weighing approx. 10 kg) are suitable for
this. |
|
|
|
These specifications apply to all engines.
Explanations regarding PR numbers
→ Chapter „Vehicle data sticker“.
Front axle
Basic
...
Always adhere to the following procedure!
Note
The vehicle must always be in unladen condition when
measuring wheel alignment
...
Other materials:
Extraction and charging valve, low-pressure side
Note
Torque wrench -V.A.G 1783- with 1/4" ratchet adapter -VAS
6234-
Appropriate insert -T10364- to remove valve core
→ Fig.
1 -
Connection with external thread and gr ...
Introduction
This chapter contains information on the following subjects:
→ Technical requirements
→ Mechanically positioned ball coupling
→ Fitting a bicycle carrier on the mechanically positioned ball coupling
→ Hitching and connecting the trailer
...
Removing and installing temperature sensor -G18- and overheating sensor
-G189
Removing
–
Dismantling and assembling auxiliary heater
→ Chapter.
–
Remove bolt -1- (4 Nm) and
remove retaining spring -2-.
...
© 2016-2024 Copyright www.vwgolf.org