VW Golf manuals

Volkswagen Golf Service & Repair Manual: Separating seat pan cover from seat pan padding

Special tools and workshop equipment required
   
   

Upholstery clip pliers -V.A.G 1634
Upholstery clip pliers -V.A.G 1634

Removing
–  Remove cover and padding → Chapter.
 

Hook -3438
Hook -3438

Vehicles with seat depth adjustment
–  Unclip beading strips -2- from locking lugs -5-.
–  Detach seat cover from tabs -4- on both sides using front end hook -3438-.
–  Remove carrier -3- with seat padding and seat depth adjustment from seat cover -1-.
 

Separating seat pan cover from seat pan padding

Continued for all vehicles
–  Pull retaining tab -3- of seat cover -1- in -direction of arrow- off seat padding -2-.
 

Separating seat pan cover from seat pan padding

–  Pull seat cover -1- off seat padding -2-.
–  Cut through upholstery clips -3- using pliers -4-.
Installing
Install in reverse order, but note the following:
  Renew all opened retaining clips → Item and fit them in the same positions.
 

Separating seat pan cover from seat pan padding

Separating seat pan cover from seat pan padding

–  Pull seat cover -1- over padding -4-.
–  Secure seat cover -1- with upholstery clips -2- in mountings -3-.
–  Use upholstery clip pliers -V.A.G 1634- for this.
–  Ensure that seat cover -1- is free of creases.
 
Specified torques
  → Chapter „Assembly overview - cover and padding for seat pan“
  → Chapter „Assembly overview - front backrest“
  → Chapter „Assembly overview - front seat“
   
Removing and installing backrest cover and backrest padding
Volkswagen R GmbH, optional equipment »R«   Note Removal and installation is described for the left seat. Apply the same instruc ...

Separating backrest cover from backrest padding
  Note Removal and installation is described for the left seat. Apply the same instructions for removal and installation of right seat components as appr ...

Other materials:

Digital sound package control unit -J525-, vehicles with Volkswagen sound system
Special tools and workshop equipment required     Torque wrench -V.A.G 1783-   Protective cap for wiring harness connector -VAS 6223/9 ...

Removing and installing high-pressure pipe
Special tools and workshop equipment required     Torque wrench -V.A.G 1331-   Insert -T10395/3- from tool set -T10395 A- ...

Assembly overview - track rod, multi-link suspension, front-wheel drive
1 -  Subframe 2 -  Bolt Renew after removing 70 Nm +180° 3 -  Wheel bearing housing 4 -  Track rod Removing and installing →  ...

© 2016-2025 Copyright www.vwgolf.org