Volkswagen Golf Service & Repair Manual: Separating and connecting Bowden cable for remote release mechanism for seat
backrest
 Note
| The separating and connecting procedures are described for
the left side of the vehicle. The separating and connecting
procedures on the right side are analogous. |
|
|
|
| – |
Fold down rear seat backrest. |
| – |
Unclip cover -1- from rear seat
backrest. |
|
|
|
| – |
Pull Bowden cable -1- out of
cable support bracket -2-. |
| – |
Remove pin -3- of Bowden cable
from mounting -4- in connecting
piece. |
| – |
Thread Bowden cable -1- out of
rear seat backrest -arrow-. |
|
|
|
| The Bowden cables are connected in reverse order. Observe
the following while doing so: |
Note
| The backrest cover must be secured all-round by cover
-1-. |
|
|
|
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
...
Note
Removal and installation are described for the left vehicle side.
Follow same instructions for the right side as appropriate.
Removing
–&nb ...
Other materials:
Changing bulbs in xenon headlights
Fig. 235 In the engine compartment: ① cover
in left-hand xenon headlight, ② cornering light, ③ turn signal, ④ side light and
daytime running light
First read and observe the introductory information
and safety warningsThe front headlight does not need to be removed when changing
bu ...
Removing and installing door inner seal
During production, a sealant is applied to the door inner
seals, which are then placed on the door flange and rolled on.
Note
When removing the seal, the sealant is distributed across
the inside of the seal. The sid ...
Removing and installing striker pin
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Note
Removal and installation are described only for the right
d ...
© 2016-2024 Copyright www.vwgolf.org
Removing and installing side padding
Removing and installing remote release operating mechanism for seat backrest