Volkswagen Golf Service & Repair Manual: Selector mechanism

Moving mechatronic unit for dual clutch gearbox -J743- into removal position by hand

  Note Only if you cannot set the mechatronic unit to removal position with the vehicle diagnostic tester, you must set the unit by hand to removal position. ...

Assembly overview - selector mechanism, manufacturer ZF

1 -  Handle with selector cover Do not remove handle without reason. Emergency release from position P → Chapter Removing ...

Other materials:

Knee airbags
Fig. 75 On the driver side: location of the knee airbag Fig. 76 Deployment zone of the knee airbag First read and observe the introductory information and safety warnings The knee airbag on the driver side is located in the lower part of the dash panel  . The airbag location is identi ...

Removing and installing sunlight penetration photosensor -G107-
Special tools and workshop equipment required     Removal wedge -3409- Removing   –  Unclip sunlight pen ...

Lowering rear axle, multi-link suspension, front-wheel drive, e-Golf
Special tools and workshop equipment required Assembly tool -3301- Assembly tool -3346- Torque wrench -V.A.G 1332- Engine and gearbox jack -V.A.G 1383 A-   Lower subframe ...