Volkswagen Golf Owners Manual: Securing child seats with a seat belt
First read and observe the introductory information
and safety warnings
It is permissible to fasten child seats with universal written on the orange label to the seats using the seat belt, but only on the seats marked in the table with a u.
| Weight class | Front passenger seat | Seats on the rear bench seat |
|---|---|---|
| Group 0 up to 10 kg |
u | u |
| Group 0+ up to 13 kg |
u | u |
| Group 1 9 to 18 kg |
u | u |
| Group 2 15 to 25 kg |
u | u |
| Group 3 22 to 36 kg |
u | u |
Securing a child seat using the seat belt
- Read and follow the child seat manufacturer's instructions.
- When placing the child seat on the front passenger seat, push the seat back as far as possible and adjust the backrest to an upright position .
- Position the child seat on the seat according to the instructions given by the child seat manufacturer.
- The seat belt height adjuster must be at the highest setting.
- Fasten the seat belt or guide it through the child seat as described in the child seat manufacturer's instructions.
- Ensure that the seat belt is not twisted.
- Insert the latch plate into the buckle for the appropriate seat and push it down until it locks securely with a click.
- In vehicles with lockable seat belts: pull the shoulder part of the belt all the way out and let the belt web roll up on the automatic belt retractor. The belt makes a clicking sound as it rolls up.
- The upper part of the belt must lie snugly and fully over the child seat.
- Pull the seat belt to check that the lower belt strap is locked and can no longer be pulled out.
- In vehicles with lockable seat belts: secure any seat belts that are not being used out of the reach of the child in the child seat, by guiding the belt behind the head restraint on the neighbouring seat. When doing this, ensure that the locking mechanism of the seat belt is not triggered! The belt should not make a clicking sound as it rolls up. Let the belt web roll up on the automatic belt retractor.
Removing child seats
Unfasten seat belts only when the vehicle is stationary .
- Press the red button in the buckle. The latch plate is released and springs out.
- Guide the belt back by hand so that it rolls up easily, without twisting the seat belt and without damaging the trim.
- Remove the child seat from the vehicle.
WARNING
- Unfasten seat belts only when the vehicle is stationary.
Using a child seat on the rear seats
First read and observe the introductory information
and safety warnings When fitting a child seat to a rear seat, the position
of the front seat must be adjusted to ensure that the child has suf ...
Securing child seats using lower anchoring points (ISOFIX, LATCH)
Fig. 78 On vehicle seat: different markings
identifying the lower anchoring points for child seats
Fig. 79 On the vehicle seat: protective
caps for the inner anchoring point
First read and obs ...
Other materials:
Removing and installing exhaust camshaft oil seal, pulley end, engine codes
CPTA, CHPA, CZEA, CZDA
Special tools and workshop equipment
required
Assembly tool -T10478 B-
Removing
–
Detach toothed belt from camshafts
→ Chapter ...
Removing and installing knee airbag with driver side knee airbag igniter
-N295-
Removing
WARNING
Observe safety instructions for
pyrotechnic components → Chapter.
...
Assembly overview – plenum chamber bulkhead
1 -
Plenum chamber bulkhead
q
Removing and installing
→ Chapter
2 -
Hexagon nut
Qty. 2
8.0 Nm
3 -
Seal, plenum chamber bulkhead
...
