Removing and installing Bowden cable for remote release mechanism for seat
backrestRemoving and installing engine speed sender -G28-
Special tools and workshop equipment
required
Socket AF 4 mm -T10370-
Removing
–
Remove noise insulation
→ General body repair ...
Setting vehicle to initial position for wheel alignment
If measured values are outside specified tolerances, this
may be because the vehicle is inclined.
Right-hand drive vehicles or e.g. vehicles with an automatic
gearbox may lean to one side slightly.
This is due to the ins ...
Overview of fitting locations - seat variants
1 -
Driver seat
Configuration depends on vehicle equipment
Assembly overview - front seat
→ Chapter
Assembly overview - front backrest
→ Chapter
Assembly overview - seat pan
→ Chapter.
2 -
Fro ...