Volkswagen Golf Service & Repair Manual: Safety instructions
- Safety precautions when working on fuel supply system
- Safety precautions during road tests in which test and measuring equipment is used
- Safety precautions when working on cooling system
- Safety precautions when working on ignition system
Identification
Engine number, engine data
The engine code and the engine number are located on the
sticker -arrow- on the up ...
Safety precautions when working on fuel supply system
Risk of injury due to highly-pressurised fuel.
The fuel system is under high pressure. Risk of injury due to fuel
which may spurt out.
–
Release high p ...
Other materials:
Calibrating Blind Spot Monitor control unit -J1086-/-J1087-
Note
Before the actual calibration process of the control units,
the calibration unit -VAS 6350- needs to be set up as described
in the following chapter.
Special tools and workshop equipment
required
...
Removing and installing front tunnel cross-piece
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Removing
–
If fitted, remove centre underbody panel
→ ...
Fitting single wire seals
Note
Single wire seals prevent the ingress of moisture and dirt
in the contact housing. They are installed, for example, in the
engine compartment and must always be reinstalled following
repairs.
As standard, ...
