First read and observe the introductory information and safety warnings
Please follow the regulations concerning running-in new parts.
Running in a new engine
Any new engine has to be run in during the first 1,500 kilometres. During its first few hours of running, the internal friction in the engine is greater than later on when all the moving parts have bedded down.
The style of driving during the first 1,500 kilometres will also affect the engine quality. Even after this time – and especially with a cold engine – drive the vehicle at moderate speeds in order to reduce engine wear and to increase the mileage that the engine can cover. Do not drive at engine speeds that are too low. Always shift down gear if the engine is not running smoothly. The following applies up to 1,000 kilometres:
From 1,000 to 1,500 kilometres, gradually increase driving performance to top speed and highest engine speed.
Running in new tyres and brake pads
If the engine is run in gently, the life of the engine will be increased and its oil consumption reduced.
Battery
(VRL007981; Edition 04.2015)
WARNING
Danger of injury! Observe warning notices and safety
regulations
→ Chapter!
...
Uprated shock absorbers and coil springs
Diving or dipping of the rear end between pulling vehicle
and trailer can be avoided with the use of uprated shock
absorbers and coil springs on the rear axle. These shock
absorbers and springs can also be retrofitted in many cases by a
Volkswagen worksh ...
Removing and installing bulb for front interior light -W1- with incandescent
bulbs
Special tools and workshop equipment
required
Removal wedge -3409-
Note
The light used for the front interior light -WX1- and the
light front passenger reading ...