VW Golf manuals

Volkswagen Golf Service & Repair Manual: Run-flat tyres, PAX, inflating tyre

Observe the following important points when inflating the tyre:
–  Only inflate after fitting the tyre with valve core installed. Check whether the beads have properly seated at 1 bar.
–  If one of the beads is not seated properly, do not let air out of the tyre, but apply the fitting roller to the appropriate bead and press on lightly while turning. The bead will then seat itself properly.
   
–  Then fill up with air until the specified inflation pressure for the vehicle is reached. Tyre gas for standard tyres can also be used.
  Note
Do NOT overfill tyre (e.g. up to 3.5 bar), even briefly, as is permissible with standard tyres.
 

Run-flat tyres, PAX, inflating tyre

Run-flat tyres, PAX
...

Run-flat tyres, PAX, wheel alignment
The procedure for adjusting the wheel alignment on vehicles with run-flat tyres (PAX) is the same as for vehicles with standard tyres. Generall ...

Other materials:

Removing and installing fog light, GTI and GTD
  Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. Removing –  Switch off ignition. ...

Removing and installing turn signal
Special tools and workshop equipment required     Torque wrench -V.A.G 1783-   Note Removal and installation are described for the left side. Removal and insta ...

Removing and installing sunlight penetration photosensor -G107-
Special tools and workshop equipment required     Removal wedge -3409- Removing   –  Unclip sunlight pen ...

© 2016-2024 Copyright www.vwgolf.org