Volkswagen Golf Service & Repair Manual: Rules for cleanliness
| When working on the fuel supply and injection system,
observe the following “5 rules” for cleanliness: |
| Thoroughly clean all unions and surrounding areas before
disconnecting. |
| Place removed parts on a clean surface and cover. Use only
lint-free cloths. |
| Carefully cover opened components or seal if repairs cannot
be carried out immediately. |
| Install clean components only. Do not remove replacement
parts from packing until immediately before installing. Do not
use parts that have not been stored in their packing (e.g. in
tool boxes etc.). |
| When the system is open: Do not work with compressed air. Do
not move vehicle. |
| Make sure that no fuel gets onto the fuel hoses. Should this
occur, the fuel hoses must be cleaned immediately. |
| Protect detached electrical connections against dirt and
moisture and only connect when they are dry. |
|
Foreign objects in engine
| To prevent the ingress of foreign bodies during work on the
engine, seal open channels of the intake section and exhaust
section with suitable bungs, for example from the engine bung
set -VAS 6122-. |
|
|
|
Contact corrosion can occur if unsuitable connecting
elements (screws, bolts, nuts, washers, etc.) are used.
For this reason, only connecting element ...
Other materials:
Assembly overview - front three-point seat belt, 4-door model and estate
1 -
Bolt
If removed due to an accident with seat belt fastened, renew bolt.
40 Nm
2 -
Belt end fitting
Removing and installing
→ Chapter
3 -
Bolts
Qty. 2
4.5 Nm
...
Adjusting wiper arms
Special tools and workshop equipment
required
Torque wrench -V.A.G 1331-
Note
If it is necessary for the wiper motor to run during the
working procedure, ...
Removing broken front side window
Removal of a broken front side window is performed in the
same manner as the removal of a broken rear window
→ Chapter.
Removing and installing rear side window
Note
...
© 2016-2024 Copyright www.vwgolf.org
Contact corrosion