Volkswagen Golf Service & Repair Manual: Routing and securing wiring

Volkswagen Golf Service & Repair Manual / Electrical system / Technical data / Repair instructions / Routing and securing wiring

Mark lines prior to removal to prevent them from being interchanged and to ensure that they are fitted in their original positions. This applies for fuel, hydraulic and vacuum lines as well as lines for activated charcoal filter system and electrical wiring. Where necessary, make sketches or take photographs.

Due to the limited space in the engine compartment, it is important to ensure that there is adequate clearance to any moving or hot components to avoid damage to lines and wiring.

Contact corrosion

Contact corrosion can occur if unsuitable fasteners (bolts, nuts, washers, etc.) are used. Therefore, only fastening elements with a special surface ...

Battery

Battery - general notes Note All instructions and notes regarding this chapter are available under → Electrical Syste ...

Other materials:

Trailer detector control unit -J345-
General description: The trailer detector control unit -J345- detects a power consumption of at least 5 W → Remark when “towing a trailer” and passes this information to various control units via the CAN data bus. ...

Assembly overview - door components
Note Only the left side is shown. The right side is similar. 1 - Rear door Removing and installing → Chapter Adjusting → Chapter 2 - Sticker Qty. 3 Diameter 28 mm If ne ...

Removing and installing tail light bulb -M2-/-M4-
Note Removal and installation are described for the left side. Removal and installation on the right side are carried out in the same way. Removing – Turn light switch to “0” position. ...