VW Golf manuals

Volkswagen Golf Service & Repair Manual: Round connector systems

  Note
If necessary, any housing catches in place (secondary locking mechanisms) must be released or removed prior to disengaging the contacts using the prescribed tool → Chapter.
   
–  Insert the release tool appropriate for the contact housing in the release port of the contact housing.
–  Grab hold of the contact by the wire and push it lightly into the contact housing -arrow-.
  Note
By pushing the contact in the direction of the contact housing, the locking tabs of the contact are lifted up by the housing edge and disengaged using the release tool.
–  At the same time, push the release tool in the direction of the contact housing -arrow- and pull out the released contact from the contact housing.
 

Round connector systems

–  The release tool can be pulled out of the contact housing again once the contact has been removed.
 

Round connector systems

Primary locking element
The primary locking mechanism is what fixes an individual crimp contact in the contact housing. If necessary, any housing catches in place (secondary ...

Flat connector systems
  Note If necessary, any housing catches in place (secondary locking mechanisms) must be released or removed prior to disengaging the contacts using the ...

Other materials:

Changing bulbs in the halogen headlights
Fig. 234 In the engine compartment: covers on the left front headlight ① dipped beam, ② main beam, side lights and daytime running lights, ③ turn signal First read and observe the introductory information and safety warningsThe front headlight does not need to be removed when changing ...

Overview of fitting locations - components inside of front passenger compartment, RHD vehicles
1 -  Air recirculation flap control motor -V113- or fresh air/recirculated air, air flow flap control motor -V425- Removing and installing air recirculation flap control motor -V113- → Chapter Removing and installing fres ...

Removing and installing track rod
Special tools and workshop equipment required Torque wrench -V.A.G 1332- Open-end insert, 38 mm -V.A.G 1923- Ball joint puller -T10187- Locking pliers for Phaeton steering rack -VAS 6199-   ...

© 2016-2024 Copyright www.vwgolf.org