First read and observe the introductory information and safety warnings
The design of the wheel bolts is matched to the rims. If different rims are fitted, the correct wheel bolts with the right length and correctly shaped bolt heads must be used. This ensures that wheels are fitted securely and that the brake system works properly .
For technical reasons, it is not generally possible to use the wheels from other vehicles. This can also apply to wheels of the same vehicle type.
The tyres and rims approved by Volkswagen are specifically matched to the characteristics of the vehicle and make a major contribution to good road holding and safe handling.
Wheel bolts
Wheel bolts must always be tightened with the correct tightening torque .
Rims with bolted-on rings
Rims with bolted-on rings consist of several components. These components are fastened using special bolts and special fastening technology. This ensures that the wheel functions properly, does not leak, remains safe and runs true. For this reason, damaged rims should be replaced. They may only be repaired by a qualified workshop. Volkswagen recommends using a Volkswagen dealership for this purpose .
Rims with bolted-on trims
Rims may have removable trims that are attached to the rim with self-locking bolts. Damaged trims may only be repaired by a qualified workshop. Volkswagen recommends using a Volkswagen dealership for this purpose .
Rims identification
In some countries, new rims are legally required to contain certain specifications on them. The following specifications may appear on the rims (varying from region to region):
WARNING
The use of unsuitable or damaged rims can impair vehicle safety and cause accidents and serious injury.WARNING
Incorrect loosening and tightening of the bolts on rims with bolted-on rings can cause accidents and serious injury.Overview of fitting locations - airbag crash sensors
1 -
Side airbag crash sensor, front passenger side -G180-
Location: in door
Safety precautions when handling crash sensors (pressure sensors) for
front side airbags
→ Chapter
Removing and installing
→ Chapter
2 -&n ...
Removing and installing fuel gauge sender -G-, vehicles with front-wheel
drive
Removing
–
Remove fuel delivery unit
→ Chapter.
–
Note colour assignment of cables -1-
for re-installation.
– ...
Hot air blower, 220 V / 50 Hz -VAS 1978/14-
Caution
When shrink-fitting, take care not to damage any
other wiring, plastic parts or insulating material with
the hot air blower.
Observe the operating instructions of the hot ai ...