First read and observe the introductory information
and safety warnings
You will need an external aerial to use a two-way radio in the vehicle.
Any retrofit installation of electrical or electronic equipment in the vehicle will affect its vehicle type approval. Under certain circumstances, this can negate the type approval for the vehicle.
Volkswagen has approved the vehicle for use with two-way radios subject to the following conditions:
The equipment can only operate at maximum range with an external aerial.
Check first with a qualified workshop if you wish to use a two-way radio with a transmitting power of over 10 watts. A qualified workshop is familiar with the technical options for retrofitting. Volkswagen recommends using a Volkswagen dealership for this purpose.
Please comply with relevant legislation and the instructions and information given in the operating manuals for radio equipment.

WARNING

CAUTION
Repairs and faults in the airbag system
Information stored in the control unitsRemoving and installing immobiliser reader coil -D2-, vehicles with keyless
access locking and starting system
Removing
–
Move steering wheel to rearmost and lowest position. Use the
entire range of adjustment of the steering column for this
purpose.
–
Remove lower steering column trim
→&nb ...
Removing and installing tyre pressure sensor, Siemens tyre pressure
monitoring system
WARNING
After tyre sealant has been used, the tyre pressure
sensor of the respective wheel must be renewed.
The Siemens system does not have a micro-encapsulated bolt.
...
Assembly overview - automatic headlight range control, RHD vehicles
1 -
Control unit
Removing and installing
→ Chapter
Versions without cornering light:
Headlight range control unit -J431-
Versions with cornering light:
Cornering light and headlight ...