Fig. 108 Dimensions and attachment points for retrofitting a towing bracket
First read and observe the introductory information and safety warningsVolkswagen recommends having the towing bracket retrofitted by a qualified workshop. The cooling system may need to be modified or heat shields may need to be fitted. Volkswagen recommends using a Volkswagen dealership for this purpose.
The dimensions must be adhered to for the retro-fitting of a towing bracket. Always observe the minimum distance given from the middle of the ball coupling to the surface of the road. This also applies when the vehicle is fully laden, including maximum drawbar load.
Dimensions :
WARNING
Electrical accessories that are not connected properly can cause faults in the entire vehicle electronics system and also cause accidents and serious injuries.WARNING
The trailer can become detached from the towing vehicle if the towing bracket is unsuitable or incorrectly fitted. This can cause serious accidents and fatal injuries.Only use towing brackets which have been approved by Volkswagen for your vehicle type.
Assembly overview - speed sensor on rear axle, all-wheel drive
1 -
ABS speed sensor
Clean inside surface of hole before inserting sensor
Coat inside surface with high-temperature paste -G 052 112 A3-
Removing and installing
→ Chapter
2 -
Bolt
...
Matting additive -LVM 769 810 A2
Designation:
Matting additive -LVM 769 810 A2-
Issued 10.2014
Product description
The matting additive -LVM 769 810 A2- is an additive for
2-pack HS clear coats and 2-pack HS ...
Assembly overview - Bowden cable
1 -
Release lever
Removing and installing
→ Chapter
2 -
Bolt
Qty. 2
1.5 Nm
3 -
Mounting bracket
4 -
Expanding nut
Qty. 2
5 - ...