Volkswagen Golf Service & Repair Manual: Repairs to contact housings using cut and clamp technique

Volkswagen Golf Service & Repair Manual / Electrical system, general information / Wiring / Wiring harness and connector repairs / Repairs to contact housings using cut and clamp technique

Note

For technical reasons, the contact housings for cut and clamp technique can only be supplied with the cut and clamp contacts inserted.

These contacts can be removed just like any other contact housing if they are not needed.

Repair wires can be supplied that already have the appropriate contacts crimped on → Electronics parts catalogue (ETKA).

Repairs to contact housings using cut and clamp technique

Fitting single wire seals

Note Single wire seals prevent the ingress of moisture and dirt in the contact housing. They are installed, for example, in the engine compartmen ...

Notes on releasing and dismantling contact housings

Note Observe the general notes on repairs to the vehicle electrical system → Chapter. To release, always ...

Other materials:

Removing and installing window channel
Removing and installing window channel Note The removal and installation sequence is only for the left window channel. Removal and installation of the right window channel are similar. ...

Overview of fitting locations - fuel supply system, Golf and Golf GTE
Note Fuel lines are secured with O-type clips. These O-type clips must always be renewed every time they are removed. Start engine if fuel tank was empty. Then start the auxiliary heater repeatedly until the heater d ...

Removing toothed belt from camshafts, engine code CHPA, CZDA
Special tools and workshop equipment required Torque wrench -VAS 6583- Counterhold -T10172- with adapter -T10172/1- Locking pin -T10340- Counterhold -T10475- Special wrench, 30 mm -T10499- ...