Volkswagen Golf Service & Repair Manual: Repairing shock absorber

Volkswagen Golf Service & Repair Manual / Running gear, axles, steering / Rear suspension, drive shaft / Suspension strut, shock absorber, spring / Repairing shock absorber

Repairing shock absorber

1 -	Shock absorber

Removing and installing → Chapter

Defective shock absorbers must always be degassed and drained before disposal → Chapter

Checking shock absorber following removal → Chapter

2 -	Protective tube

3 -

Bump stop

4 -	Shock absorber mounting

5 -

Nut

Renew after removing

Loosening and tightening → Fig.

25 Nm

6 -

Cover

Special tools and workshop equipment required

Torque wrench -V.A.G 1331-

Repairing shock absorber

Shock absorber set -T10001-

Ring spanner insert (commercial type, e.g. »Hazet 6630c-21«)

Repairing shock absorber

Loosening and tightening threaded connection for shock absorber mounting

1 -	Ring spanner insert (commercial type, e.g. »Hazet 6630c-21«)

2 -	Socket -T10001/9-

3 -	Commercially available ratchet handle

4 -	Torque wrench -V.A.G 1331-

5 -	Socket -T10001/1-

6 -	Shock absorber mounting

Install in reverse order of removal, observing the following:

Repairing shock absorber

–	Slide protective tube -1- onto shock absorber mounting -2-.

–	Fit cable tie -3- and tighten.

Note

The fastener -arrow- of the cable tie -3- must be located within area -a-.

Specified torques

→ Chapter „Repairing shock absorber“

Repairing shock absorber

Removing and installing shock absorber, multi-link suspension, right shock absorber

Special tools and workshop equipment required Torque wrench -V.A.G 1332- Torque wrench -V.A.G 1410- Spring compressor -V.A.G 1752/1 ...

Removing and installing spring, torsion beam axle

Special tools and workshop equipment required Spring compressor -V.A.G 1752/1- &nb ...

Other materials:

Removing and installing digital sound package control unit -J525
Special tools and workshop equipment required Protective cap for wiring harness connector -VAS 6223/9- If the control unit is replaced, select the Replace function of the resp ...

Warning lamp and coolant temperature display
Fig. 194 Coolant temperature display in instrument cluster: Ⓐ cold; Ⓑ normal; Ⓒ warning First read and observe the introductory information and safety warnings In normal driving conditions, the needle will be in the middle section of the scale. The temperature may also rise when the ...

Removing and installing air distribution housing
Note The illustration shows a left-hand drive vehicle. The removal and installation procedure is identical for both versions. Removing – Remove heater ...