Volkswagen Golf Service & Repair Manual: Repair instructions

Volkswagen Golf Service & Repair Manual / General body repairs, interior / Technical data / Repair instructions

Contact corrosion

Contact corrosion can occur if unsuitable fastening elements (screws, bolts, nuts, washers) are used.

For this reason, only connecting elements with a special surface coating have been fitted.

In addition, rubber, plastic and adhesives are made of non-conductive materials.

In case of doubt about the reusability of parts renew them → Electronic Parts Catalogue.

Please note:

It is recommended to use genuine parts which are tested and compatible with aluminium.
The use of VW parts is recommended.
Damage due to contact corrosion is not covered by the warranty.

Routing and securing wires

If hydraulic, pneumatic or electrical lines are disconnected or removed and installed, make corresponding drawings or photos. This guarantees installation in the original position.

Safety instructions for automatically dimmable interior mirror

WARNING The mirror glass is made of several layers and contains an electrolyte t ...

Interion equipment

...

Other materials:

Removing and installing retainer for digital sound package control unit -J525-
Special tools and workshop equipment required Torque wrench -V.A.G 1783- Removing – Removing digital sound package control unit -J525- &# ...

Checklist
To ensure your own safety and the safety of your passengers, observe the following actions in the specified order : Stop the vehicle at a safe distance away from moving traffic and on a suitable surface . Switch on the hazard warning lights using the button . Switch on the ...

Additional safety instructions for curtain airbag
Inspect trims for damage prior to installing them. Always renew damaged pillar trims; never repair. Ensure proper seating of trims when installing them. When performing r ...