Volkswagen Golf Service & Repair Manual: Renewing rear bonded rubber bush for lower suspension link
Special tools and workshop equipment required |
Tube for wheel bearing -3345- |
Removing and installing tool -VW 459- |
– |
Remove lower suspension link. |
Vehicles with manual gearbox or dual clutch gearbox 0CW
→ Chapter |
Vehicles with dual clutch gearbox 0D9
→ Chapter |
|
|
|
Pressing out bonded rubber bush |
– |
Press out bonded rubber bush as illustrated. |
4 - |
Tube for wheel bearing -3345- |
5 - |
Thrust plate -VW 401- |
|
|
|
Installation position of bonded rubber bush |
The embossed arrow points between the two markings
-arrows A- in the transverse link. |
The cam -arrow B- must always
point to outside of vehicle. Open kidney faces to centre of
vehicle. |
|
|
|
Pressing in bonded rubber bush |
– |
Press in bonded rubber bush as illustrated. |
2 - |
Sleeve -VW 459/2-, inner shoulder of sleeve
-arrow- faces downwards |
4 - |
Tube for wheel bearing -3345- |
5 - |
Thrust plate -VW 401- |
Note
Press in bonded rubber bush until wheel bearing tube -3345-
makes contact with transverse link. |
|
|
|
Greasing bonded rubber bush: |
The kidney-shaped area -1- of
the bonded rubber bush must be greased. |
– |
Grease must be applied to the kidney-shaped area
-1- from above. |
– |
Use grease -G 052 150 A2- |
|
|
|
– |
The quantity of grease required for both sides is, as shown,
about 1 cm -dimension a-. |
Half of the quantity of grease (about 0.5 cm) must be
applied to each kidney-shaped area. |
– |
The grease must be applied to the top using a commercially
available brush. |
– |
No grease may be applied to the area contacting the
suspension link. |
– |
Install lower suspension link
→ Chapter. |
Vehicles with manual gearbox or dual clutch gearbox 0CW
→ Anchor |
Vehicles with dual clutch gearbox 0D9
→ Anchor |
|
|
|
Special tools and workshop equipment required
Assembly tool -T10219-
Thrust plate -VW 402-
Press tool -VW 411-
...
Other materials:
Notes for wheel alignment
Wheel alignment must be performed only using a VW/AUDI-approved
wheel alignment unit!
Whenever wheels are aligned, both the front and rear axles
must be measured.
–
Carry alignment out with the wheel alignm ...
Removing and installing rear interior light/reading light
Removing
Caution
Danger of damage to component surfaces.
When using leverage tools, mask visible areas of the
component with commercially available adhesive tape.
...
Correct sitting position
Fig. 41 There must be a distance of at
least 25 cm between the driver and the steering wheel The distance to the dash panel
must be at least 10 cm in the knee area
Fig. 42 Correct seat belt routing and head
restraint adjustment
First read and observe the introductory information
and safe ...
© 2016-2024 Copyright www.vwgolf.org