Volkswagen Golf Service & Repair Manual: Renewing LSU Lambda probe (6-pin)
Note
If necessary, replace attachment parts, cable ties or
marking rings to match the uniform probe to the defective probe
as specified. |
The wires should not be crimped or cut as otherwise the
function of the Lambda probe will be impaired. |
– |
Remove the old Lambda probe. |
|
|
|
– |
Place both Lambda probes next to each other so that the
sensor housings are at the same height. |
|
|
|
– |
Tie back any excess in the uniform probe length (approx. 50
- 250 mm) to the size of the defective probe and secure with
cable ties -1-. |
– |
Install the new Lambda probe in the vehicle. |
|
|
|
Note
If necessary, replace attachment parts, cable ties or
marking rings to match the uniform probe to the defective probe
as specified.
...
Note
In addition to identifying by way of the part number, the
protective tube can also be used as a means of identification.
Type D1, ...
Other materials:
Removing and installing front right reading light button -E634-
Note
The front right reading light button -E634- is an integral
part of the front interior light -WX1- and cannot be removed
individually.
Removing
–
Remove front interior light -WX1-
& ...
Luggage net
Fig. 101 In the luggage compartment: luggage
net fitted flat
Fig. 102 In the luggage compartment: fastening
rings ① and hooks ③ for fixing the luggage net
First read and observe the introductory information
and safety warnings The luggage net stops light items of luggage from sliding ...
Adjusting toe on rear axle, multi-link suspension
Special tools and workshop equipment
required
Torque wrench -V.A.G 1332-
–
Loosen nut -1-.
–&nb ...
© 2016-2024 Copyright www.vwgolf.org