Volkswagen Golf Service & Repair Manual: Renewing LSF Lambda probe (4-pin)

Note

If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified.

Do not repair Lambda probe wires, since this can result in malfunctions.

–	Remove the defective Lambda probe.

–	Place both Lambda probes next to each other so that the sensor housings are at the same height.

Renewing LSF Lambda probe (4-pin)

–	Tie back any excess in the uniform probe length (approx. 50 - 250 mm) to the size of the defective probe and secure with cable ties -1-.

–	Check that the connector housing of the Lambda probe is compatible with the onboard supply side.

–	If necessary, replace the onboard supply system connector with the Lambda probe connector housing supplied → Chapter

Note

The connector housing should only be replaced on older vehicles. On new vehicles, the connector housing coding matches.

Observe pin assignment. For reasons of clarity, respective pins in new connector housing have a colour marking.

Further notes can be found in the leaflet of the new Lambda probe.

–	Install the new Lambda probe in the vehicle.

Renewing LSF Lambda probe (4-pin)

Note Do not repair Lambda probe wires, since this can result in malfunctions. If necessary, replace attachment parts, cabl ...

Note If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified. ...

Distribution of the refrigerant circuit components and their influence on the high-pressure and low-pressure sides
On the high-pressure side, there are the condenser, the receiver and the restrictor or expansion valve that acts as the separation between the high-pressure fluid and low-pressure fluid sides. High pressure is created because the restric ...

Removing and installing remote control receiver for auxiliary coolant heater -R149-, Golf and Golf GTE
Note If the remote control receiver for auxiliary coolant heater -R149- is renewed, the remote control receiver for auxiliary coolant heater -R149- needs to be adapted to the auxiliary and supplementary heater using the vehicle diagnostic tester ...

Removing and installing bulb for number plate light -X4-/-X5-
Note If an LED number plate light is faulty, the entire number plate light must be renewed. Removing: – Switch off ignition and all electrical consumers. – If i ...