Volkswagen Golf Service & Repair Manual: Renewing Lambda probe

Volkswagen Golf Service & Repair Manual / Electrical system, general information / Wiring / Renewing Lambda probe

Note

Do not repair Lambda probe wires, since this can result in malfunctions.

If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified.

Identify the lambda probe by way of the protective tube as required → Chapter.

Anti-corrosion treatment

Caution Missing anti-corrosion treatment results in damage to the onboard supply. &nbs ...

Renewing LSF Lambda probe (4-pin)

Note If necessary, replace attachment parts, cable ties or marking rings to match the uniform probe to the defective probe as specified. ...

Other materials:

Vehicles with multilink suspension
The connecting pipe can be cut through at the cutting point in order to renew the centre and rear silencers separately. Cutting point is marked by an indentation on circumference of exhaust pipe. Special tools and ...

Perform battery test with battery tester with printer -VAS 6161-.
WARNING Danger of injury! Observe warning notices and safety regulations → Chapter! Special tools and workshop equipment required ...

Tyre sizes for vehicles with four-wheel drive
The following points must be observed for vehicles with four-wheel drive: Only tyres of the same make, design and tread pattern may be fitted to the front and rear axles. Different tyre rolling circumferences ...