Volkswagen Golf Service & Repair Manual: Renewing input shaft seal
| Special tools and workshop equipment
required |
|
|
|
| There are 2 oil seals in gearbox at clutch end. Both oil
seals can be renewed without dismantling the gearbox. If only
the oil seals are being renewed, it is not necessary to adjust
the clutch engagement mechanism. |
|
|
|
| – |
Lever out outer oil seal. |
|
|
|
Caution
| The clutch can be damaged. |
| Only drive in oil seal until it is flush, in order
to avoid closing off oil drilling located behind it.
Otherwise, bearing can no longer be supplied with enough
oil. |
|
| – |
Drive in new oil seal with a plastic hammer so it is flush
with clutch housing, as shown in illustration. |
| Shoulder of pipe section -VW 415 A- points upwards
-arrow-. |
| – |
Install clutch engagement mechanism
→ Chapter. |
| – |
Install dual clutch
→ Chapter. |
| → Chapter „Renewing oil seal for inner input shaft“ |
|
|
|
Special tools and workshop equipment
required
Support device -T10323-
...
Special tools and workshop equipment
required
Oil seal extractor -T10420-
...
Other materials:
Battery
Battery - general notes
Note
All instructions and notes regarding this chapter are
available under
→ Electrical System, General Information; Rep. gr.27.
...
Notes on safety
Safety precautions during a road test
using test and measuring equipment
Observe the following if test and measuring equipment is
required during a road test:
Risk of accidents due to distraction and inadequate securing ...
Fixing position of subframe, multi-link suspension, front-wheel drive, Golf
GTE
Special tools and workshop equipment
required
Locating pins -T10096-
Engine and gearbox jack -VAS 6931-
I ...
© 2016-2024 Copyright www.vwgolf.org
Note
Installing dual clutch
Renewing oil seal for inner input shaft